Electro-voice 2.1P Bedienungsanleitung

Electro-Voice® EVID 12.1P User Manual

Electro-Voice® 8Obtaining Warranty ServiceTo obtain warranty service, a customer must deliver the product, prepaid,to Electro-Voice® Service or to any

Electro-Voice® 9• Higher-level foreground music in bass heavy applications suchas dance floors, amusement arcades, or loud bars: use one pairof EVID

Electro-Voice® 10Appendix C: Painting Process• Remove the four screws securing the front hatch and lift off thehatch panel. Carefully twist and lift o

Electro-Voice® 11Appendix D: TroubleshootingGuideProblem Possible Cause(s) Action1. No sound Amplifier Verify that that the line level signal cablesX

Electro-Voice® 12Appendix E: TechnicalSpecificationsFrequency Response (-10 dB): 42 Hz  160 HzMax Calculated SPL1 @ 1M: 126 dBLF Amplifier Power: 650

Electro-Voice® 13Notes

Electro-Voice® U.S.A. and Canada:For customer orders, contact the Customer Service department at:800/392-3497 Fax: 800/955-6831For warranty repair or

Electro-Voice® Table of ContentsProduct Description ... 1Product Feature

Electro-Voice® Product DescriptionThe 12.1P is a self contained, powered 12" subwoofer providing over300 watts continuous output to the speaker.

Electro-Voice® Packing ListFigure 4: EVIDTM 12.1P Packing List2Below is a list of parts included withthe EVIDTM 12.1P subwoofer. Theparts are illustr

Electro-Voice® Step-by-Step Installation & WiringStep 1: Mount the BracketThe mounting bracket can be installed two ways (see Figures 5 and 6),all

Electro-Voice® 4Figure 7: Wiring ConfigurationStep 3: Wire the SpeakerA typical wiring configuration is shown in Figure 7. It is highly advisableto s

Electro-Voice® 5enclosure hangs from the top clip, always install the lower one to secureagainst possible disengagement of the top clip. Straighten th

Electro-Voice® 6Mounting through a suspended ceiling gridOn the rear of the enclosure install and tighten two 3/8-16-thread forgedsteel eyebolts (one

Electro-Voice® 7Safety Agency ComplianceThe EVID 12.1P bracket system has successfully passed EIA 636 at asafety factor of 6:1. The bracket system is